How To Refinish A Wood Table

How To Refinish A Wood Table

Most up to date tabletops are made out of plywood. Nonetheless, there are millions of antiques with stable wooden tabletops. Many or most of those tops have been effectively used and are beat up, dented and even climate broken. The enduring great thing about hardwood is effectively definitely worth the time it takes to repair it. That is one of many benefits of stable wooden: It may be nearly utterly restored by hand.

Splits or Cracks , Study the tabletop totally earlier than starting any restoration. Search for deep cracks, skinny spidery strains or splits alongside laminated glue strains which may go right through the highest. Deep defects like these have to be crammed with epoxy glue as an alternative of putty or wooden dough. Powdered resin glue is offered from dwelling enchancment shops. Such a glue is coloured to match the wooden species. Combine it with water and drive it down into the cracks with a putty knife. It is going to dry onerous after 24 hours. Use it in any open cracks.

Prep , For all different small holes, gouges, dents or cracks that aren’t severe, use a putty knife to fill them with wooden dough. If there are any seen splinters or unfastened items, squirt a small quantity of wooden glue underneath them after which safe them with masking tape. Liberally smear putty over any tough or pitted areas. Wait at the very least one hour for all glue and putty to dry.

Belt Sanding , To sand beat-up picket surfaces of any sort, use a belt sander. Begin out with an 80-grit belt to take away wooden quickly. Maintain the sander with each arms and at all times sand parallel with the grain patterns; by no means sand perpendicular to the grain. Maintain the sander completely flat towards the floor and by no means tip it sideways; it may reduce deep gouges whether it is allowed to tip. When the floor of the wooden takes on a pure, naked wooden look and all the putty and glue is eliminated, put down the belt sander.

Hand Sanding , Proceed sanding with 100-grit sandpaper connected to a hand block. At all times sand parallel with the grain. Utterly sand the desk by hand with the block till it seems to be constant and easy. Lean down and let gentle mirror off the floor. Should you can see scratches, preserve sanding till they’re gone. Put 180-grit sandpaper on the block and sand the desk another time till uniformly easy. Alternatively, use an oscillating instrument with a hook and loop pad accent and rising grits of sandpaper to save lots of time on handbook sanding.

Spraying , After sanding, apply stain if desired. Let it dry for one hour after which spray the highest with one coat of aerosol lacquer. Let the lacquer dry for 30 minutes after which sand the highest once more with a contemporary piece of 180-grit sandpaper on a hand block. There will probably be a light-weight coat of advantageous white lacquer mud after sanding; depart it on the highest because it aids in curing the subsequent coat. Spray the desk once more, transferring in patterns parallel with the grain. When the desk has an excellent moist coat of lacquer, let it dry for one hour to complete, or add as much as two extra coats for a deeper end.

See Also : how to refinish a wood table with paint , how to refinish a wood table with stain , how to refinish a wood table without sanding